995dc61bf5
Since MR !33891 EGL only supports a software driver (LLVM).
Routine dri3_x11_connect at
src/egl/drivers/dri2/platform_x11.c fails if DRI3 is not
available. So at that location variable *allow_dri2 should be set.
Looking at the major codition, we see it is not executed
if LIBGL_DRI3_DISABLE is set. In that case the hardware driver
is activated as desired. Previously this was not needed.
Also it is not practical, and not necessary.
I do not understand the major condition, so I did not change it.
This causes some duplicate coding.
Fixes: 323bad6b18 ("egl/x11: split out dri2 init entirely")
Signed-off-by: GKraats <vd.kraats@hccnet.nl>
Acked-by: Mike Blumenkrantz <michael.blumenkrantz@gmail.com>
Part-of: <https://gitlab.freedesktop.org/mesa/mesa/-/merge_requests/34530>
`Mesa <https://mesa3d.org>`_ - The 3D Graphics Library ====================================================== Source ------ This repository lives at https://gitlab.freedesktop.org/mesa/mesa. Other repositories are likely forks, and code found there is not supported. Build & install --------------- You can find more information in our documentation (`docs/install.rst <https://docs.mesa3d.org/install.html>`_), but the recommended way is to use Meson (`docs/meson.rst <https://docs.mesa3d.org/meson.html>`_): .. code-block:: sh $ meson setup build $ ninja -C build/ $ sudo ninja -C build/ install Support ------- Many Mesa devs hang on IRC; if you're not sure which channel is appropriate, you should ask your question on `OFTC's #dri-devel <irc://irc.oftc.net/dri-devel>`_, someone will redirect you if necessary. Remember that not everyone is in the same timezone as you, so it might take a while before someone qualified sees your question. To figure out who you're talking to, or which nick to ping for your question, check out `Who's Who on IRC <https://dri.freedesktop.org/wiki/WhosWho/>`_. The next best option is to ask your question in an email to the mailing lists: `mesa-dev\@lists.freedesktop.org <https://lists.freedesktop.org/mailman/listinfo/mesa-dev>`_ Bug reports ----------- If you think something isn't working properly, please file a bug report (`docs/bugs.rst <https://docs.mesa3d.org/bugs.html>`_). Contributing ------------ Contributions are welcome, and step-by-step instructions can be found in our documentation (`docs/submittingpatches.rst <https://docs.mesa3d.org/submittingpatches.html>`_). Note that Mesa uses gitlab for patches submission, review and discussions.