96d331766a
We were using this for indirect loads of the shader input thread payload, but there's no reason we can't use it for constant access too. In this case we can just MOV from the ATTR file directly without a special opcode that turns into MOV_INDIRECT later. We also allow it to load multiple components now. This is useful for say, returning vec4 pushed inputs. And, we allow it in more stages than just the fragment stage. Reviewed-by: Alyssa Rosenzweig <alyssa.rosenzweig@intel.com> Part-of: <https://gitlab.freedesktop.org/mesa/mesa/-/merge_requests/38482>
`Mesa <https://mesa3d.org>`_ - The 3D Graphics Library ====================================================== Source ------ This repository lives at https://gitlab.freedesktop.org/mesa/mesa. Other repositories are likely forks, and code found there is not supported. Build & install --------------- You can find more information in our documentation (`docs/install.rst <https://docs.mesa3d.org/install.html>`_), but the recommended way is to use Meson (`docs/meson.rst <https://docs.mesa3d.org/meson.html>`_): .. code-block:: sh $ meson setup build $ ninja -C build/ $ sudo ninja -C build/ install Support ------- Many Mesa devs hang on IRC; if you're not sure which channel is appropriate, you should ask your question on `OFTC's #dri-devel <irc://irc.oftc.net/dri-devel>`_, someone will redirect you if necessary. Remember that not everyone is in the same timezone as you, so it might take a while before someone qualified sees your question. To figure out who you're talking to, or which nick to ping for your question, check out `Who's Who on IRC <https://dri.freedesktop.org/wiki/WhosWho/>`_. The next best option is to ask your question in an email to the mailing lists: `mesa-dev\@lists.freedesktop.org <https://lists.freedesktop.org/mailman/listinfo/mesa-dev>`_ Bug reports ----------- If you think something isn't working properly, please file a bug report (`docs/bugs.rst <https://docs.mesa3d.org/bugs.html>`_). Contributing ------------ Contributions are welcome, and step-by-step instructions can be found in our documentation (`docs/submittingpatches.rst <https://docs.mesa3d.org/submittingpatches.html>`_). Note that Mesa uses gitlab for patches submission, review and discussions.