613eaac7b5
Support for spilling shared registers to normal registers is still TODO. There are also several improvements to be made, like rematerialization. Note, there is one behavior change to register pressure accounting: we now include half registers in the current full pressure directly in mergedregs mode, rather than adding the max half pressure to the max full pressure afterwards, which might result in lower calculated max pressure in some cases with half registers. This is needed for spilling, since we need to make sure the total pressure including half registers is below the maximum at each instruction. Because the entire pass is rewritten, including the register pressure calculating parts, it didn't seem worth it to separate out this change. Part-of: <https://gitlab.freedesktop.org/mesa/mesa/-/merge_requests/12033>
`Mesa <https://mesa3d.org>`_ - The 3D Graphics Library ====================================================== Source ------ This repository lives at https://gitlab.freedesktop.org/mesa/mesa. Other repositories are likely forks, and code found there is not supported. Build & install --------------- You can find more information in our documentation (`docs/install.rst <https://mesa3d.org/install.html>`_), but the recommended way is to use Meson (`docs/meson.rst <https://mesa3d.org/meson.html>`_): .. code-block:: sh $ mkdir build $ cd build $ meson .. $ sudo ninja install Support ------- Many Mesa devs hang on IRC; if you're not sure which channel is appropriate, you should ask your question on `OFTC's #dri-devel <irc://irc.oftc.net/dri-devel>`_, someone will redirect you if necessary. Remember that not everyone is in the same timezone as you, so it might take a while before someone qualified sees your question. To figure out who you're talking to, or which nick to ping for your question, check out `Who's Who on IRC <https://dri.freedesktop.org/wiki/WhosWho/>`_. The next best option is to ask your question in an email to the mailing lists: `mesa-dev\@lists.freedesktop.org <https://lists.freedesktop.org/mailman/listinfo/mesa-dev>`_ Bug reports ----------- If you think something isn't working properly, please file a bug report (`docs/bugs.rst <https://mesa3d.org/bugs.html>`_). Contributing ------------ Contributions are welcome, and step-by-step instructions can be found in our documentation (`docs/submittingpatches.rst <https://mesa3d.org/submittingpatches.html>`_). Note that Mesa uses gitlab for patches submission, review and discussions.