Jesse Natalie
4fb076fc22
While enhanced barriers is a *much* closer model to Vulkan's, there's still one big mismatch: Vulkan's "transfer" concept supports clears, copies, and resolves, while D3D's closest match only supports copies. So when doing clears and resolves, we need to transition from the copy layout to the correct layout, and then back. Internal barriers are done for some meta scenarios as well as render pass initial layout transitions. These look more or less the same as non-enhanced, we just want to avoid mixing the two paradigms if possible. Part-of: <https://gitlab.freedesktop.org/mesa/mesa/-/merge_requests/20324>
`Mesa <https://mesa3d.org>`_ - The 3D Graphics Library ====================================================== Source ------ This repository lives at https://gitlab.freedesktop.org/mesa/mesa. Other repositories are likely forks, and code found there is not supported. Build & install --------------- You can find more information in our documentation (`docs/install.rst <https://mesa3d.org/install.html>`_), but the recommended way is to use Meson (`docs/meson.rst <https://mesa3d.org/meson.html>`_): .. code-block:: sh $ mkdir build $ cd build $ meson .. $ sudo ninja install Support ------- Many Mesa devs hang on IRC; if you're not sure which channel is appropriate, you should ask your question on `OFTC's #dri-devel <irc://irc.oftc.net/dri-devel>`_, someone will redirect you if necessary. Remember that not everyone is in the same timezone as you, so it might take a while before someone qualified sees your question. To figure out who you're talking to, or which nick to ping for your question, check out `Who's Who on IRC <https://dri.freedesktop.org/wiki/WhosWho/>`_. The next best option is to ask your question in an email to the mailing lists: `mesa-dev\@lists.freedesktop.org <https://lists.freedesktop.org/mailman/listinfo/mesa-dev>`_ Bug reports ----------- If you think something isn't working properly, please file a bug report (`docs/bugs.rst <https://mesa3d.org/bugs.html>`_). Contributing ------------ Contributions are welcome, and step-by-step instructions can be found in our documentation (`docs/submittingpatches.rst <https://mesa3d.org/submittingpatches.html>`_). Note that Mesa uses gitlab for patches submission, review and discussions.