Eric Anholt
33f38605e9
I'm working on moving the db410c CI from docker to LAVA, which means we get to boot a custom kernel. To do that, we need to enable ARCH_QCOM in the kernel, save the dtb around, and include abootimg in our container so that we can generate combined kernel/dtb/ramdisk images for fastboot. LAVA's fastboot support is unable to pack the overlay into an abootimg image, just a cpio rootfs. We could flash the cpio rootfs after overlay addition, but that takes 2 minutes to do, and causes wear on the devices. Instead, we'll bring up the network at boot and use wget to fetch the overlay. We'll want network support anyway, so that we can transfer the failure xmls back to the gitlab job's artifacts at some point. Since the msm GPU and realtek network firmware increase our payload by 3MB, add in firmware compression so that it doesn't waste as much RAM on devices not using it. Reviewed-by: Tomeu Vizoso <tomeu.vizoso@collabora.com> Tested-by: Marge Bot <https://gitlab.freedesktop.org/mesa/mesa/-/merge_requests/3928> Part-of: <https://gitlab.freedesktop.org/mesa/mesa/-/merge_requests/3928>
`Mesa <https://mesa3d.org>`_ - The 3D Graphics Library ====================================================== Source ------ This repository lives at https://gitlab.freedesktop.org/mesa/mesa. Other repositories are likely forks, and code found there is not supported. Build & install --------------- You can find more information in our documentation (`docs/install.html <https://mesa3d.org/install.html>`_), but the recommended way is to use Meson (`docs/meson.html <https://mesa3d.org/meson.html>`_): .. code-block:: sh $ mkdir build $ cd build $ meson .. $ sudo ninja install Support ------- Many Mesa devs hang on IRC; if you're not sure which channel is appropriate, you should ask your question on `Freenode's #dri-devel <irc://chat.freenode.net#dri-devel>`_, someone will redirect you if necessary. Remember that not everyone is in the same timezone as you, so it might take a while before someone qualified sees your question. To figure out who you're talking to, or which nick to ping for your question, check out `Who's Who on IRC <https://dri.freedesktop.org/wiki/WhosWho/>`_. The next best option is to ask your question in an email to the mailing lists: `mesa-dev\@lists.freedesktop.org <https://lists.freedesktop.org/mailman/listinfo/mesa-dev>`_ Bug reports ----------- If you think something isn't working properly, please file a bug report (`docs/bugs.html <https://mesa3d.org/bugs.html>`_). Contributing ------------ Contributions are welcome, and step-by-step instructions can be found in our documentation (`docs/submittingpatches.html <https://mesa3d.org/submittingpatches.html>`_). Note that Mesa uses gitlab for patches submission, review and discussions.