28c842e4b7
The Vulkan spec says the following:
> If imageType is VK_IMAGE_TYPE_2D and flags contains
> VK_IMAGE_CREATE_CUBE_COMPATIBLE_BIT, extent.width and extent.height
> must be equal and arrayLayers must be greater than or equal to 6
This makes a lot of sense, as these are also requirements for being able
to create cubemaps from them in the first place.
Let's thread a bit more careful, and only set this bit in these cases.
This matters in the new case of setting this flag on 2D array textures.
In the other cases, this should already be the case.
I haven't seen this trigger any issues, I just realized this while
reading the Vulkan-spec.
Fixes: 1887ff2ebb ("zink: mark 2d-arrays as cube-compatible")
Reviewed-by: Hoe Hao Cheng <haochengho12907@gmail.com>
Part-of: <https://gitlab.freedesktop.org/mesa/mesa/-/merge_requests/11081>
`Mesa <https://mesa3d.org>`_ - The 3D Graphics Library ====================================================== Source ------ This repository lives at https://gitlab.freedesktop.org/mesa/mesa. Other repositories are likely forks, and code found there is not supported. Build & install --------------- You can find more information in our documentation (`docs/install.rst <https://mesa3d.org/install.html>`_), but the recommended way is to use Meson (`docs/meson.rst <https://mesa3d.org/meson.html>`_): .. code-block:: sh $ mkdir build $ cd build $ meson .. $ sudo ninja install Support ------- Many Mesa devs hang on IRC; if you're not sure which channel is appropriate, you should ask your question on `OFTC's #dri-devel <irc://irc.oftc.net/dri-devel>`_, someone will redirect you if necessary. Remember that not everyone is in the same timezone as you, so it might take a while before someone qualified sees your question. To figure out who you're talking to, or which nick to ping for your question, check out `Who's Who on IRC <https://dri.freedesktop.org/wiki/WhosWho/>`_. The next best option is to ask your question in an email to the mailing lists: `mesa-dev\@lists.freedesktop.org <https://lists.freedesktop.org/mailman/listinfo/mesa-dev>`_ Bug reports ----------- If you think something isn't working properly, please file a bug report (`docs/bugs.rst <https://mesa3d.org/bugs.html>`_). Contributing ------------ Contributions are welcome, and step-by-step instructions can be found in our documentation (`docs/submittingpatches.rst <https://mesa3d.org/submittingpatches.html>`_). Note that Mesa uses gitlab for patches submission, review and discussions.